Bosch Dishwasher E22 or E92-40 Error: Blocked Filter Fix
Also shown or searched as: E:22, E-22, E9240, E92-40, E:92-40, E92
E22 on a Bosch dishwasher, or E:92-40 on newer models, means the filter at the bottom of the tub is blocked. Unplug it, twist the filter system out, take apart the coarse, fine and micro filters, rinse them and lock them back in. If E22 returns, Bosch's list adds the pump cover, the drain hose and the air gap.
What to try first
Safety: Unplug the dishwasher before you lift the filters out, and give a hot cycle time to cool. Go slowly in the sump: Bosch's manual cautions that sharp debris such as broken glass can end up near the drain pump.
- 1
Unplug the dishwasher first
Switch it off and pull the plug or turn off its breaker. Bosch's support page for the four-digit version of this code makes that the first step, before any check inside the tub.
- 2
Twist the filter system out
Slide the lower rack out. Turn the coarse filter counterclockwise and lift the whole filter system out of the tub floor. The manual asks you to make sure nothing falls into the sump while it is out.
- 3
Take the three filters apart
Pull the micro filter down to free it. Then press the locking catches on the coarse filter together and lift the coarse filter out of the fine filter, so you end up with three separate pieces.
- 4
Rinse each piece and clear the debris ring
Hold every piece under running water. The manual singles out the rim of debris that builds up between the coarse and fine filters, so work that loose carefully. For a caked filter, Bosch's filter guide suggests warm, soapy water and a scrub brush.
- 5
Clip it together and lock it in
Push the coarse filter back into the fine filter until its catches click, refit the micro filter, set the system back in the tub floor and turn the coarse filter clockwise until the arrow markings match up. A filter that is only resting in place is not locked.
- 6
Clear the code and test with a rinse
Plug the dishwasher back in. If E22 is still on the display, use Bosch's reset: on most models you hold Reset or Start for about four seconds, and the machine empties itself before the cycle ends. Then run a rinse and watch whether the code comes back.
- 7
Still there? Work down the rest of Bosch's list
With the power off again, Bosch's E22 checklist moves on to the drain pump cover under the filter, which must click down, the drain hose under the sink, which must have no kinks or sharp bends, and the air gap beside the faucet if you have one.
Most likely causes of E22
1. Food scraps, seeds or labels packed into the filters (most common)
You can see a mat of debris on the fine filter or a gritty ring where the coarse and fine filters meet, and the filters have not been taken apart for a long time.
2. A filter system put back loose or not locked (common)
E22, or food left on the dishes, started soon after the filters were cleaned, or the coarse filter will not turn far enough for its arrow to line up with the one on the tub floor.
3. Debris below the filters, in the sump or around the pump cover (common)
The filters come out clean, yet dirty water still sits in the sump under them and the code is back within a cycle or two.
4. A kinked drain hose or a clogged air gap (less common)
With clean filters the tub still empties slowly, and under the sink the hose is bent sharply or the air gap cap is full of food.
5. A blocked non-return valve at the drain pump outlet (less common)
Every part an owner can reach is clear, yet water still will not leave the sump and the code persists.
When to call a pro
- E22 keeps coming back with clean, locked filters and a clear pump cover, hose and air gap. Bosch's next step at that point is its customer support.
- Dirty water stays in the sump after a reset although nothing is blocking the filter or the pump cover.
- Getting to the non-return valve or the pump outlet means disconnecting the drain tube under the tub.
What a E22 repair costs
$90–$400
HomeGuide's 2026 national figures, parts and labor: a new dishwasher filter $90 to $175, of which the part is $20 to $45, and a drain pump $100 to $400 if the blockage turns out to be below the filter. Rinsing the filter at home is free; a service call on its own runs $70 to $130.
SourceWhat E22 means, and why Bosch's two pages differ
Bosch's E22 self-help page gives a single cause: the dishwasher filter is blocked. The filter is where food particles collect, and the page asks you to remove it, wash it under running water with mild soap and a soft brush, and put it back. Fred's Appliance Academy adds what follows from that: with the filter blocked, excess water builds up in the sump.
Bosch's error-code list reads more broadly. It says E22 can have a number of causes and gives four checks in order: the filter, the drain pump, the drain pump hose, and the air gap or drain hose. An older BSH technician sheet, for model SHX5AVF5UC, files E:22 under the drain pump and labels it water in sump. So start with the filter, and expect the pump to be next in line.
E:92-40 on newer models is the same message
Newer Bosch dishwashers show four-digit codes. The use and care manual for the SHE53B75UC lists E:92-40 as filters soiled or blocked, with a single instruction: clean the filters. Bosch's US error-code list prints it as E9240 or E92-40 and gives it the same four checks as E22, without the reset step.
Bosch's French support page for E9240 says the code is the result of the dishwasher's own diagnosis and can point at the filter, the drain hose or the drain pump. It also names a part the US pages leave out: the non-return valve at the outlet of the drain pump, which can block as well.
Three filters, one lock
Bosch's filter system is not a single screen. The manual shows three parts: a coarse filter that clips into a fine filter, plus a separate micro filter. Debris tends to gather in a rim where the coarse and fine filters meet, which is why taking the parts apart cleans better than rinsing the assembly in one piece.
Locking it back matters as much as the cleaning. The same manual lists filters that are inserted incorrectly or not engaged as a cause of food left on dishes, and its answer is to twist them into place. Bosch's South Africa page, written for E22, adds that most filters must be locked in position.
How often the filter needs a look
Bosch gives more than one answer. The manual says to check the filters for residue after each wash, and Bosch's French page suggests a rinse with hot water after every wash. Bosch's US filter guide recommends a fuller clean every few months for optimum results.
On connected models, the manual says the Home Connect app will tell you when the filters need cleaning. On models with a Machine Care program but no reminder, Bosch recommends running it every two months, and its first steps are wiping out heavy soiling and cleaning the filters.
What a technician will check
- The sump and the pump inlet below the filter, for debris that rinsing the filters cannot reach.
- The non-return valve at the drain pump outlet, reached by disconnecting the drain tube; it is cleaned, or replaced if it stays blocked.
- The drain pump and its connection to the controls, when water stays in the sump although the pump cover is clear.
- The seat of the filter in the tub floor, so that a damaged filter is not letting food past it.
- The drain hose and the house plumbing; Bosch France notes that a faulty plumbing installation can also set the four-digit code.
What fixed it for other readers
No reader fixes yet. If you cleared E22, tell others what worked.
Reader fixes are shared by visitors and checked for safety, not tested by us.
Questions people ask about Bosch E22
Should I reset the dishwasher before or after cleaning the filter?
After. A reset on its own leaves the blockage where it is. Bosch's list puts the reset after the filter, pump and hose checks, and the reset itself pumps out the water left in the tub and cancels the cycle in about a minute. Fred's Appliance Academy tries a reset first, but cleaning the filter is still the fix it gives.
Do I need a new filter, and what does one cost?
Only if a piece is cracked or warped, or its catches no longer click. HomeGuide puts the part at $20 to $45 and a fitted replacement at $90 to $175 nationally. Order it by the E-Nr printed on the rating label inside the door, so it matches your model.
Is E22 the same as the E24 drain error?
No. E24 means the dishwasher cannot drain, and Bosch's E24 page starts at the hose, the sink connection and a newly fitted disposal. E22 starts inside the tub, at the filter. After the filter, Bosch's E22 list runs through the same pump, hose and air gap checks it gives for E24.
What does the water tap symbol mean on a Bosch dishwasher?
It points at the water coming in, not at the filter in the tub. Bosch's Singapore support page for the symbol gives three checks: no kinks in the fill hose or the drain hose, about 10 liters (2.6 gallons) a minute from the tap when it is fully open, and a clean filter where the supply hose connects. For its water supply indicator, the US manual for the SHE53B75UC adds a closed water supply valve: open it, end the cycle and start a new one, and call Bosch if it happens again.
Sources
- E22 Bosch Dishwasher Error Code | Dishwasher Troubleshooting | Bosch (Bosch US Owner Support, checked November 6, 2026)
- Dishwasher Error Codes | Support | Bosch (Bosch US Owner Support, checked November 6, 2026)
- How to Reset the Dishwasher | Troubleshooting | Bosch (Bosch US Owner Support, checked November 6, 2026)
- How to Clean your Dishwasher Filter (Bosch US (BSH Home Appliances Corporation), checked November 6, 2026)
- Bosch Dishwasher Error E22: Troubleshooting Guide - Bosch Home South Africa (Bosch Home Appliances (South Africa), checked November 6, 2026)
- Que signifie l'apparition d'un code E9240 ou E92-40 sur votre lave-vaisselle Bosch ? (Bosch Electromenager (France), checked November 6, 2026)
- Water tap symbol | Bosch (Bosch Home Appliances (Singapore), checked November 6, 2026)
- Dishwasher SHE53B75UC Use and Care Manual (BSH Home Appliances (Bosch), checked November 6, 2026)
- Bosch SHX5AVF5UC dishwasher error codes (technician sheet) (ApplianceAid (copy of a BSH service document), checked November 6, 2026)
- Bosch Dishwasher Error Codes: What Do They Mean? (Fred's Appliance Academy, checked November 6, 2026)
- How Much Does Dishwasher Repair Cost? (2026) (HomeGuide, checked November 5, 2026)
